Removing The Fan Cage Assembly - Lenovo ThinkServer TD200 Installation And User Manual

Removing the fan cage assembly

Attention:
v Replace a hot-swap fan within 30 seconds of removal.
v To ensure proper cooling and airflow, do not operate the server for more than 2
To remove the front fan cage assembly, do the following:
1. Read the safety information (see "Safety" on page vii and "Installation
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Unlock and remove the side cover (see "Removing the side cover" on page 43).
4. Carefully position the server on its side so that it is lying flat and facing up.
5. Rotate the power-supply cage assembly out of the chassis. Lift up the
6. Remove the air baffle (see "Removing the air baffle" on page 44).
7. Press in on the fan cage assembly release buttons on both sides of the chassis
46
ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide
minutes with the side cover removed.
guidelines" on page 37).
all external cables.
Note: Do not allow the server to fall over.
power-supply cage handle and pull the power-supply cage assembly all the way
up until the retainer latch locks the cage in place on the chassis.
1
Power supply
2
Power-supply handle
to release the fan cage assembly from the connector on the chassis. Lift the fan
cage assembly up and out of the chassis and set it aside.