Removing A 3.5-Inch Hot-Swap Hard Disk Drive - Lenovo ThinkServer TD200 Installation And User Manual

Removing a 3.5-inch hot-swap hard disk drive

Attention:
than 10 minutes without either a drive or a filler panel installed in each drive bay.
To remove a 3.5-inch hot-swap SAS or hot-swap SATA hard disk drive, do the
following:
1. Read the safety information (see "Safety" on page vii and "Installation
2. Unlock the side cover.
3. Open the bezel. Place your finger on the pull-point area on the left side of the
4. Rotate the drive tray handle of the drive assembly to the open position.
5. Grasp the handle of the drive and pull the drive out of the bay.
To maintain proper system cooling, do not operate the server for more
guidelines" on page 37).
bezel door and rotate it away from the server.
Chapter 5. Installing optional devices and replacing customer replaceable units
73