Using The Webbios Utility; Starting The Webbios Utility; Main Menu Of The Webbios Utility - Lenovo ThinkServer TD200 Installation And User Manual

3. Select the type of array that you want to create.
4. In the RAID Disk column, use the Spacebar or Minus (-) key to select [Yes]
5. Continue to select drives, using the Spacebar or Minus (-) key, until you have
6. Press C to create the disk array.
7. Select Save changes then exit this menu to create the array.
8. Exit the Setup Utility.

Using the WebBIOS utility

The WebBIOS configuration utility enables you to create and manage RAID
configurations on LSI SAS controllers. The WebBIOS utility resides in the SAS
controller BIOS and operates independently of the operating system. The WebBIOS
utility provides a configuration wizard to guide you through the configuration of
virtual disks and physical arrays.

Starting the WebBIOS utility

Do the following to start the WebBIOS utility and access the main menu:
1. After you turn on the power and when the computer is starting, you are
2. Select an adapter from the list.
3. Click Start. The main WebBIOS utility interface is displayed. You can toggle

Main menu of the WebBIOS utility

The main menu includes the following options:
Adapter Properties
Scan Devices
Virtual Disks
Physical Drives
Configuration Wizard
Adapter Selection
(select) or [No] (deselect) to select or deselect a drive from a RAID disk.
selected all the drives for your array.
prompted to press Ctrl + H when the following message is displayed:
Copyright© LSI Logic Corporation
Press <Ctrl><H> for WebBIOS
between the physical view and logical view of the storage devices that are
connected to the controller. Click Physical View or Logical View on the menu
in the left pane to change the view.
From this view, you can display and modify the properties of the SAS that is
currently selected.
From this view, you can re-scan the physical and virtual disks for any
changes in the drive status or physical configuration.
From this view, you can display and modify the virtual disk properties,
delete virtual disks, initialize disks, and perform other tasks.
From this view, you can view the physical drive properties, create hot-spare
disks, and perform other tasks.
Select this to start the Configuration Wizard and create a new storage
configuration, clear a configuration, or add a new configuration.
From this view, you can select a different SAS adapter. Then, you can view
information about the adapter and the drives connected to it, or create a
new configuration for the adapter.
Chapter 6. Configuring the server
145