Removing The Front Adapter-Retention Bracket; Installing The Front Adapter-Retention Bracket; Removing The Battery - Lenovo ThinkServer TD200 Installation And User Manual

4. Install the side cover (see "Installing the side cover" on page 134).
5. Lock the side cover, if necessary.
6. Reconnect the external cables and power cords; then, turn on the attached

Removing the front adapter-retention bracket

To remove the front adapter-retention bracket, do the following:
1. Read the safety information (see "Safety" on page vii and "Installation
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 43).
4. Open the front and rear adapter-retention brackets.
5. Remove all adapters and place the adapters on static-protective surface (see
6. Lift the top of the front adapter-retainer bracket and release the hinge point;
7. If you are instructed to return the front adapter-retention bracket, follow all

Installing the front adapter-retention bracket

To install the front adapter retention bracket, do the following:
1. Insert one hole on the front adapter-retention bracket into the hinge point.
2. Position the other hole and insert the adapter-retention bracket into the hinge
3. Install the adapters (see "Installing an adapter" on page 96).
4. Close the front and rear adapter retention brackets.
5. Install the side cover (see "Installing the side cover" on page 134).
6. Lock the side cover.
7. Reconnect the external cables and power cords; then, turn on the attached

Removing the battery

The following notes describe information that you must consider when removing
and replacing the battery in the server:
v The lithium battery must be handled correctly to avoid possible danger. If you
v You must replace the battery with a lithium battery of the same type from the
v To avoid possible danger, read and follow the following safety statement.
54
ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide
devices and turn on the server.
guidelines" on page 37).
and external cables.
"Removing an adapter" on page 95).
Note: You might find it helpful to note where each adapter is installed before
removing the adapters.
then, remove the bottom hinge point and remove the bracket from the chassis.
packaging instructions, and use any packaging materials that are supplied to
you for shipping .
point.
devices and turn on the server.
replace the battery, you must adhere to the following instructions.
same manufacturer.