Removing The Side Cover - Lenovo ThinkServer TD200 Installation And User Manual

4. From inside of the top section of the bezel door, slide the blue tab up to unlock

Removing the side cover

Important: Before you install optional hardware, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts,
if an operating system is installed. If the server is not working correctly, see the
Hardware Maintenance Manual for diagnostic information.
To remove the server side cover, do the following:
Attention:
removed might damage server components. For proper cooling and airflow, replace
the side cover before turning on the server.
1. Read the safety information (see "Safety" on page vii and "Installation
2. Turn off the server and all attached devices (see "Turning off the server" on
3. Unlock the side cover.
4. Press the cover-release latch down (as shown in the illustration); then, remove
the bezel media door (slide the tab down when you want to lock it); then, grasp
the pull-point area on the left side of the media door and pull the door open.
Note: To close and lock the bezel media door, rotate the door to the closed
position and slide the blue tab down to lock it.
1
Bezel media door
2
Media door lock
Operating the server for more than 30 minutes with the side cover
guidelines" on page 37).
page 35); then, disconnect all power cords and external cables.
the cover and set it aside.
Chapter 5. Installing optional devices and replacing customer replaceable units
43