Lenovo ThinkServer TD200 Installation And User Manual page 115

for x4 and x8 adapters. These same rules apply to the other PCI slots also.
Check the information that comes with your adapter for compatibility information.
– Slots on the system board:
- Slot 1, PCI Express Gen 2 x8 (x8)
- Slot 2, PCI Express Gen 2 x16 (x8)
- Slot 3, PCI Express Gen 2 x8 (x4)
- Slot 4, PCI Express Gen 2 x8 (x4)
- Slot 5, PCI Express Gen 2 x8 (x8)
- Slot 6, PCI 32-bit/33 MHz
– If you install the one-slot PCI extender card in the server:
- One additional PCI Express Gen 1 x8 (x4) slot is available
– If you install the two-slot PCI extender card in the server:
v You can install full-length adapters that are supported in slots 2, 3, 4, and 5 on
the system board, and the slots on the one-slot or two-slot extender cards. You
can only install half-length adapters in slots 1 and 6.
v The 32-bit slot 6 supports 5.0 V keyed PCI adapters; they do not support 3.3 V
keyed adapters. Universal adapters are supported in slots 4 and 5 if they are
universally keyed.
v You can install the ServeRAID-BR10i SAS/SATA controller, the optional
ServeRAID-MR10i SAS/SATA controller, or the optional ServeRAID-MR10is
VAULT SAS/SATA controller in slots 1 of hot-swap SAS or hot-swap SATA
models. These ServeRAID adapters are not supported on the simple-swap
models.
v The ServeRAID-BR10i adapter comes standard on hot-swap SAS and hot-swap
SATA models and provides RAID levels 0, 1, and 1E support. You can order the
ServeRAID-MR10i adapter which provides RAID levels 0, 1, 5, 6, 10, 50, and 60
support, and the optional ServeRAID-MR10is adapter with an encryption 1078
DE chip provides RAID levels 0, 1, 5, 6, 10, 50, and 60 support.
To ensure that any of your ServeRAID 10i, 10is, or 10M adapters function
properly on UEFI-based servers, make sure that the adapter firmware level is
updated to at least 11.x.x-XXX , and the supporting drivers.
Attention: Some cluster solutions require specific code levels or coordinated
code updates. If the device is part of a cluster solution, verify that the latest level
of code is supported for the cluster solution before you update the code.
v The server scans PCI Express slot 1 and PCI Express slots 2 and 3 to assign
system resources. Then, the server starts the devices in the following order, if
you have not changed the default startup sequence: PCI Express slot 1, PCI
Express slot 2, PCI slot 6, and PCI Express slot 3.
v For a list of supported options for the server, see
http://www.lenovo.com/thinkserver.
To install an adapter, do the following:
Note: The instructions in this section apply to any PCI adapter (for example, video
graphics adapters or network adapters).
1. Read the safety information (see "Safety" on page vii and "Installation
guidelines" on page 37).
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the side cover. See "Removing the side cover"
on page 43.
3. Carefully position the server on its side so that it is lying flat and facing up.
Chapter 5. Installing optional devices and replacing customer replaceable units
97