Accessing The Graphical User Interface; Setup Wizard - Aruba Networks PowerConnect W Clearpass 100 Software Deployment Manual

3. Reinitialize database – Destroys the entire configuration of the appliance and resets to the factory
default state. All guest accounts, operator logins, RADIUS accounting records, application
configuration, and customization will be lost.
4. Change shell password – Sets the new shell password used to access the console user interface.
5. Reset admin Web password to default – Recovers a forgotten Web administration password by
restoring the default setting of Amigopod.
6. Reboot appliance – Shuts down and restarts the appliance.
7. Reset network settings to default – Restores the original factory default network configuration for
the appliance.
8. Display physical address information – Displays the MAC addresses of the appliance's network
adapters.
9. Logout – Exits the console user interface.
10. Shutdown appliance – Shuts down and powers off the appliance.

Accessing the Graphical User Interface

After starting the Amigopod appliance, the initial startup screen will be displayed in the console.
Type the displayed URL into your Web browser to open the Amigopod appliance's graphical user interface
(GUI).
You may use either http: or https: to access the GUI. However, if you use https: to access the setup wizard, you
may receive a warning message from your browser about the default self-signed SSL certificate that is installed on
the appliance. See
SSL certificate.

Setup Wizard

When you first log in to the appliance using the graphical user interface, you will be guided through an
initial configuration process, which is explained in more detail below.
34 | Setup Guide
"SSL Certificate" in the Administrator Tasks chapter for information about installing a new
Amigopod 3.7 | Deployment Guide