Setup Guide; Chapter 3 Setup Guide; Hardware Appliance Setup; Default Network Configuration - Aruba Networks PowerConnect W Clearpass 100 Software Deployment Manual

This section covers the initial deployment and configuration of the Amigopod Visitor Management
Appliance.
If you have a hardware appliance, See
Amigopod Visitor Management Appliance in a virtual machine, See
chapter.

Hardware Appliance Setup

Refer to the Hardware Setup Guide sheet included in the box with the appliance for detailed installation
information for the chassis and rack assembly.

Default Network Configuration

The AMG-HW-100 and AMG-HW-2500 appliances have two gigabit Ethernet network ports on the rear of the
chassis. See

Figure 5 Rear port configuration for AMG-HW-100/-2500 appliances

The factory default network configuration for these ports is:

Table 5 Default Port configurations

Item
Configuration Method
IP Address
Netmask
Gateway
DNS
Adapter Name
Amigopod 3.7 | Deployment Guide
"Hardware Appliance Setup"
Figure 5.
MGT Port
Static
192.168.88.88
255.255.255.0
192.168.88.1
–
eth0
Chapter 3

Setup Guide

in this chapter. If you are using the
"Virtual Appliance Setup"
LAN Port
DHCP
–
–
–
–
eth1
in this
Setup Guide | 31