The Paper Is Too Small - Canon imagePROGRAF iPF6450 Basic Manual

The paper is too small.

When Detect Mismatch in the Control Panel
menu is set to Pause, the type of paper loaded
does not match the type specified in the printer
driver.
When Detect Mismatch in the Control Panel
menu is set to Warning, the type of paper loaded
does not match the type specified in the printer
driver.
The paper is too small. The paper is too small.
When Detect Mismatch in the Control Panel
menu is set to Pause or Hold Job, paper smaller
than the size specified in the printer driver is loa-
ded.
When Detect Mismatch in the Control Panel
menu is set to Warning, paper smaller than the
size specified in the printer driver is loaded.
The paper is too small.
The paper is too small.
A sheet has come out of the printer during printing.
The loaded paper is too small.
(When you have attempted to print a test print sheet or other
printer status information.)
134
Cause
Cause
1.
2.
1.
2.
Cause
2.
Replace the loaded paper with paper of the type and size you have specified in
the printer driver.
(See "Loading and Printing on Rolls.")
(See "Loading and Printing on Sheets.")
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
You can continue to print, but note that this error may cause problems in the printing
results.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
Adjust the paper size setting in the printer driver to match the size loaded in the printer
as follows.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Change the paper size setting in the printer driver to the size loaded in the printer
and try printing again.
Replace the loaded paper with paper of a size that matches the size setting in the
printer driver as follows.
Press ▲ or ▼ to select Change Paper, and then press the OK button to stop print-
ing.
Replace the loaded paper to match the settings in the printer driver and try printing
again.
(See "Loading and Printing on Rolls.")
(See "Loading and Printing on Sheets.")
You can continue to print, but note that this error may cause problems in the printing
results.
1.
Press the OK button and remove the sheet.
2.
Confirm the paper size and setting.
3.
Reload the paper.
(See "Loading Sheets in the Feed Slot.")
Replace the roll with a roll 10 inches in width or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
→User's Guide
→User's Guide
Corrective Action
→User's Guide
→User's Guide
Corrective Action
→P.18
→P.14
→User's Guide
→P.9
→P.11
iPF6450
Basic Guide