Appendix B: Helpful Cli Commands - SMC Networks EZ Connect SMC70032AE User Manual

SMC70032AE> bsp sysinfo
SMC70032AE> tell bun list channels
These commands show the cell/packet errors that might be happening when
transmitting and receiving data on the ATM (ADSL) line or Ethernet line to the
PC or hub
For Graphical User Interface:
Click on the "Physical" option under the "STATUS" Menu

Appendix B: Helpful CLI Commands

After the ADSL Line has been connected, you can check ADSL line status using
the following commands:
SMC70032AE> bsp
SMC70032AE bsp> help all
Commands are:
channel - shows channel data
defects - shows defect
down - stops activation process and shuts down the line
gasp - sends dying gasp
glite - applies G.Lite mode to modem
mode - shows the current line status/mode
multi - multi-mode configuration command
line - shows general line data
perf - shows the performance counter
up - Line activity
vendor - shows vender id
version - shows information about ADSL modem software version
sysinfo - when an ADSL Link exists it shows all line data (speed/error/noise/
margin).
debug
bspconfig - shows bsp setup information of the Modem as it is being activated
obj - shows firmware version
To check the following parameters are related to line condition, use the sysinfo
command.
SMC70032AE bsp>sysinfo
modem uptime : 17 hours 28 minitues 32 seconds
Operation Mode Seletected : G.DMT
54