SMC Networks EZ Connect SMC70032AE User Manual page 40

SMC70032AE> config save
Saving configuration...Configuration saved.
SMC70032AE> restart
2. Add and set up the Ethernet gateway using the following commands:
SMC70032AE> ip device add ethernet ether //edd 192.168.1.1
SMC70032AE> ip subnet add ethernet.home . 192.168.1.1 ff:ff:ff:00
Note: If the Subnet Mask is class C (255.255.255.0, or Hexadecimal ff:ff:ff:00),
the subnet command is not needed.
3. Set up the values assigned by your service provider for VPI ("x"), VCI ("y"),
modem IP address (in this example 20.1.136.2), and encapsulation mode
("mode=").
SMC70032AE> ip device add rfc1483 ptp
//bun/port=atm/rfc1483=true/mode=llcrouted/vpi=x/vci=y
202.1.136.2 (Encapsulation method is set to LLC)
Or,
SMC70032AE>ip device add rfc1483 ptp
//bun/port=atm/rfc1483=true/mode=vcmuxrouted/vpi=x/vci=y
202.1.136.2 (Encapsulation method is set to VCMUX)
Then use the following commands:
SMC70032AE>ip relay all
SMC70032AE>ip route add default 0.0.0.0 202.1.136.1 0:0:0:0
(Sets up default routing table between LAN subnet and WAN subnet)
SMC70032AE> ip nat add rfc1483
interface to the RFC1483 interface (ADSL interface))
SMC70032AE> config save
Saving configuration...Configuration saved.
SMC70032AE> restart
Note: If you wish to connect additional PCs you can connect the LAN port on the
SMC70032AE to a hub or switch. Set all the PCs connected to the Hub or
Switch to "Obtain an IP address automatically." You will also need to set up the
DHCP server functions as listed under the DHCP Server section.
40
(this activates NAT from the Ethernet