Disconnect Time - Panasonic KX-TA624 Installation Manual

422
Description
Selection
Default
Programming
Conditions
Feature Reference
4-80 System Programming
4.2

Disconnect Time

Determines the amount of time to send the disconnect signal from
the system to the Central Office or host PBX.
• Outside (CO) line number: 1 – 6,
• Time (seconds): 0.5 sec / 1.5 sec / 4.0 sec
All outside (CO) lines – 1.5 sec
1. Enter 422.
Display: Disconnect Time
2. Press NEXT.
Display: CO NO?
3. Enter an outside (CO) line number.
Pressing NEXT also can enter outside (CO) line number 1.
Display example: CO 1:1.5sec
4. Keep pressing SELECT until the desired time is displayed.
5. Press STORE.
6. To program another outside (CO) line, press NEXT or
PREV, or SELECT and enter the desired outside (CO) line
number.
7. Repeat steps 4 through 6.
8. Press END.
• The disconnect time must be longer than the requirement of the Central
Office or host PBX.
• To assign all outside (CO) lines to the same selection, press the
in step 3. In this case, the display will show: CO
Section 3, Features
Flash
System Programming
( = all outside (CO) lines)
key
:Mixed.