Panasonic KX-TA624 Installation Manual page 112

D
*10: The DISA Busy Mode is selected in program [506] "DISA Busy Mode". There are three modes
as follows:
• Disconnect – the caller hears a busy tone and the call is disconnected.
• Call Waiting – the destination extension hears the call waiting tone if they have enabled Call
• DISA2 – if "MODE2" is assigned in program [502] "OGM Mode Selection" and a message is
recorded in OGM2, the caller hears the message and the system waits for the new
destination.
*11: The DISA Ring Timer Before Intercept starts. The destination telephone(s) will ring for the time
programmed in program [508] "DISA Ringing Time before Intercept".
*12: In this case, the system disregards the security type and does not accept the line access code. If
nothing is recorded in OGM2, the caller will hear a busy tone and the call is disconnected.
*13: The OGM is sent to the caller according to programs [414]–[416] "Outside (CO) Line Mode –
Day/Night/Lunch" and [502] "OGM Mode Selection". If an OGM is not recorded, the DISA
Wait Timer After OGM programmed in program [505] "DISA Waiting Time after OGM" will
start immediately.
When the system detects a CNG tone while the OGM is being sent, the call is sent to the FAX
extension. When the system detects a cyclic tone or a CPC signal while the OGM is being sent,
the call is disconnected.
*14: The DISA Wait Timer After OGM starts. The system waits for a number from the caller during
the time programmed in program [505] "DISA Waiting Time after OGM". When the system
detects a CNG tone during the programmed time, the call is sent to the FAX extension. When the
system detects a cyclic tone or a CPC signal during the programmed time, the call is
disconnected.
*15: After the DISA Wait Timer After OGM or the Intercept Timer for Internal DISA expires, the
system regards that nothing was dialed .
*16: The system treats the call according to program [510] "DISA No Dial Mode" as follows.
• Disconnect – the call is disconnected.
• Intercept – the call is sent to the extensions programmed in programs [408]–[410] "Flexible
*17: The DISA Ring Timer After Intercept starts. The destination telephone(s) will ring for the time
programmed in program [509] "DISA Ringing Time after Intercept". If the call is not answered
during the programmed time, the call will be disconnected.
*18: The FAX extension assigned in program [503] "FAX Connection" receives the call. When the
extension is busy, the system sends a busy tone to the Fax. If the call is not answered after
40 seconds, the call will be disconnected.
Program [514] "Fax Tone Detection" sets how many times the CNG tone must be detected before
the system recognizes the incoming signal as facsimile data.
3-50 Features
Waiting.
Ringing Assignment — Day/Night/Lunch". If all of the extensions are assigned to
"Disable", the call will be disconnected.
3 Features