Mitsubishi FUEL Manual page 77

Item Inspection Inspection contents
No. item
22 Crank angle D
sensor D
D
D
24 Vehicle Drive at 40 km/h
speed sen-
sor
25 Barometric Ignition switch: ON
pressure
sensor
26 Idle position Ignition switch: ON
switch
Check by operating
accelerator pedal re-
peatedly
27 Power steer- Engine: Idling
ing fluid
pressure
switch
28 A/C switch Engine: Idling
(when A/C switch is (when A/C switch is
ON, A/C compressor
should be operating.)
29 Inhibitor Ignition switch: ON
switch
<A/T>
MPI <4G6> -
Engine: Cranking Compare the engine
Tachometer: speed readings on
Connected the tachometer and
the MUT-II.
Engine: Idling When engine cool-
Idle position ant temperature is
switch: ON - 20_C
When engine cool-
ant temperature is
0_C
When engine cool-
ant temperature is
20_C
When engine cool-
ant temperature is
40_C
When engine cool-
ant temperature is
80_C
At altitude of 0 m
At altitude of 600 m
At altitude of 1,200 m
At altitude of 1,800 m
Throttle valve:
Set to idle position
Throttle valve:
Slightly open
Steering wheel sta-
tionary
Steering wheel turn-
ing
A/C switch: OFF
A/C switch: ON
P or N
D, 2, L or R
Troubleshooting
Normal condition
Accord
1,275 - 1,475 rpm
1,225 - 1,425 rpm
1,100 - 1,300 rpm
950 - 1,150 rpm
650 - 850 rpm
Approximately 40
km/h
101 kPa
95 kPa
88 kPa
81 kPa
ON
2
OFF*
OFF
ON
OFF
ON
P or N
D, 2, L or R
13A-77
Inspection Reference
procedure page
No.
Code No. 13A-32
P0335
Code No. 13A-39
P0500
Code No. 13A-12
P0105
Code No. 13A-41
P0510
Code No. 13A-42
P0551
Procedure 13A-72
No. 30 No. 30
Procedure 13A-71
No. 29