Mitsubishi FUEL Manual page 60

13A-60
From the previous page
MUT-II Data list
11 Oxygen sensor
OK: Changes between 0 - 400 mV and 600 - 1,000 mV during
idling
Check the fuel pressure. (Refer to P.13A-85*.)
Check the following items.
D Check the ignition coil, spark plugs, spark plug cables.
D Check the EGR control system.
D Check the compression pressure.
D Check the fuel filter or fuel line for clogging.
NOTE:
*: Refer to the '97 GALANT Workshop Manual (Pub. No. PWDE9611)
INSPECTION PROCEDURE 16
The feeling of impact or vibration when accelerating
In cases such as the above, the cause is probably that there is an ignition leak
accompanying the increase in the spark plug demand voltage during acceleration.
MUT-II Self-Diag code
Are diagnosis codes displayed?
Check the following items.
D Check the ignition coil, spark plugs, spark plug cables.
D Check for occurrence of ignition leak.
INSPECTION PROCEDURE 17
The feeling of impact or vibration when decelerating.
Malfunction of the ISC system is suspected.
MUT-II Self-Diag code
Are diagnosis codes displayed?
Check the ISC servo for operation sound. (Refer to P.13A-95*.)
MUT-II Data list
14 Throttle position sensor (Refer to P.13A-75.)
MUT-II Data list
26 Idle position switch (Refer to P.13A-75.)
Clean the throttle valve area. (Refer to P.13A-81*.)
NOTE:
*: Refer to the '97 GALANT Workshop Manual (Pub. No. PWDE9611)
MPI <4G6> -
OK
OK
OK
No
No
OK
OK
OK
Troubleshooting
NG
Check the fuel pressure.
(Refer to P.13A-85*.)
Probable cause
D Malfunction of the ignition system
Yes
Refer to P.13A-8, INSPECTION CHART FOR DIAGNOSIS
CODES.
Probable cause
D Malfunction of the ISC system
Yes
Refer to P.13A-8, INSPECTION CHART FOR DIAGNOSIS
CODES.
NG
Check the ISC system. (Refer to P.13A-39, INSPECTION PROCE-
DURE FOR DIAGNOSIS CODE P0505.)
NG
Check the throttle position sensor system. (Refer to P.13A-18, IN-
SPECTION PROCEDURE FOR DIAGNOSIS CODE P0120.)
NG
Check the idle position switch system.
(Refer toP.13A-41, INSPECTIONPROCEDURE FORDIAGNOSIS
CODE P0510.)
OK
1. Inspect the intake of
air into the air intake
system
D Broken
manifold gasket
D Broken vacuum
hose
D PCV valve does
not operate.
D Broken air intake
hose
2. Check the injector for
clog.
intake