Mitsubishi FUEL Manual page 255

From the previous page
OK
Measure at accelerator pedal position
sensor connector C-172.
D Use test harness (MB991658) to
connect terminals No. 6, No. 7,
No. 8 only, and measure at the
pick-up harness side.
D Ignition switch: ON
(1) The voltage between terminal 6
and earth
OK: Accelerator pedal fully re-
leased: 0.935 - 1.135 V
Accelerator pedal fully de-
pressed: 4.0 V or higher
(2) The voltage between terminal 7
and earth
OK: 0.5 V or more
(3) The voltage between terminal 8
and earth
OK: 4.8 - 5.2 V
OK
Measure at throttle valve controller
connector C-160.
D Measure voltage at the throttle
valve controller connector
terminals.
D Ignition switch: ON
D The resistance between 20 and
earth
OK: Accelerator pedal fully re-
leased: 0.935 - 1.135 V
Accelerator pedal fully de-
pressed: 4.0 V or higher
NOTE:
*: Refer to the '99 GALANT Workshop Manual (Pub. No. PWDE9611-A)
GDI -
Troubleshooting
(1) NG
Adjust the accelerator pedal position
sensor (Refer to P.13I-99*.)
Check the following connectors: C-81,
C-160
Check the harness wire between
accelerator pedal position sensor (2nd
channel) and the throttle valve controller,
and repair if necessary.
(2), (3) NG
Check the following connectors: C-81,
C-160
Check the harness wire between
accelerator pedal position sensor (2nd
channel) and the throttle valve controller,
and repair if necessary.
NG
Check the following connectors: C-81,
C-160
Check the harness wire between
accelerator pedal position sensor (2nd
channel) and the throttle valve controller,
and repair if necessary.
OK
Check the following connector: C-160
Check the trouble symptoms.
Replace the throttle valve controller.
NG
OK
NG
OK
NG
OK
NG
OK
NG
13I-61
Repair
Repair
Repair
Repair