INSPECTION PROCEDURE 11
When the engine is cold, it stalls at idling. (Die out)
In such cases as the above, the cause is probably thatthe air/fuelmixture isinappropriate
when the engine is cold, or that the intake air volume is insufficient.
Were the battery terminals disconnected?
MUT-II Self-Diag code
Are diagnosis codes displayed?
Does the engine stall right after the accelerator pedal is released?
Is engine-idling stable after the warming-up?
Check the ISC servo for operation sound. (Refer to P.13A-95*.)
Check the injector for operation sound.
MUT-II Data list
26 Idle position switch (Refer to P.13A-75.)
MUT-II Data list
21 Engine coolant temperature sensor (Refer to P.13A-75.)
MUT-II Actuator test
10 EGR control solenoid valve (Refer to P.13A-80.)
Check the fuel pressure. (Refer to P.13A-85*.)
Check the ignition timing.
(Refer to GROUP 11A - On-vehicle Service.)
Check the following items.
D Check the ignition coil, spark plugs, spark plug cables.
D Check the compression pressure.
D Check the engine oil viscosity.
NOTE:
*:
Refer to the '97 GALANT Workshop Manual (Pub. No. PWDE9611)
MPI <4G6> -
No
No
No
Yes
OK
OK
OK
OK
OK
OK
OK
Troubleshooting
Probable cause
D Malfunction of the ISC system
D Malfunction of the throttle body
D Malfunction of the injector system
D Malfunction of the ignition system
Yes
After warming-up, let the engine run at idling for 10 minutes.
Yes
Refer to P.13A-8, INSPECTION CHART FOR DIAGNOSIS
CODES.
Yes
Clean the throttle valve
area.
(Refer to P.13A-81*.)
No
Check if the unstable idling (Rough idling, hunting).
(Refer to P.13A-51, INSPECTION PROCEDURE 8.)
NG
Check the ISC system. (Refer to P.13A-39, INSPECTION PROCE-
DURE FOR DIAGNOSIS CODE P0505.)
NG
Check the injector system. (Refer to P.13A-28, INSPECTION PRO-
CEDURE FOR DIAGNOSIS CODE P0201, P0202, P0203, P0204.)
NG
Check the idle position switch system. (Refer to P.13A-41, INSPEC-
TION PROCEDURE FOR DIAGNOSIS CODE P0510.)
NG
Check the engine coolant temperature sensor system.
(Refer toP.13A-16, INSPECTIONPROCEDURE FORDIAGNOSIS
CODE P0115.)
NG
Check the EGR control solenoid valve system. (Refer to P.13A-36,
INSPECTION PROCEDURE FOR DIAGNOSIS CODE P0403.)
NG
Check that the crank angle sensor is installed properly.
13A-55
Check and adjust the
fixed SAS.
(Refer to P.13A-83*.)