Mitsubishi FUEL Manual page 216

13I-22
From the previous page
OK
Measure at throttle position sensor
connector B-07.
D Use test harness (MB991536) to
connect the connector, and
measure at the pick-up harness.
D Ignition switch: ON
(1) Voltage between terminal 1 and
earth
OK: 4.8 - 5.2 V
(2) Voltage between terminal 2 and
earth
OK: Accelerator pedal fully re-
leased: 0.45 - 0.80 V
Accelerator pedal fully de-
pressed: 4.2 - 4.9 V
(3) Voltage between terminal 3 and
earth
OK: 0.5 V or less
OK
Measure at throttle valve controller
connector C-160.
D Measure voltage at the throttle
valve controller connector
terminals.
D Ignition switch: ON
D Voltage between terminal 7 and
earth
OK: Accelerator pedal fully re-
leased: 0.45 - 0.80 V
Accelerator pedal fully de-
pressed: 4.2 - 4.9 V
NOTE:
*: Refer to the '99 GALANT Workshop Manual (Pub. No. PWDE9611-A)
GDI -
Troubleshooting
(1) NG
Check the following connector:
(3) NG
C-160
Check the harness wire between the
throttle position sensor and the
throttle valve controller, and repair if
necessary.
(2) NG
Adjust the throttle position sensor.
(Refer to P.13I-98*.)
Check the following connector:
C-160
Check the harness wire between the
throttle position sensor and the
throttle valve controller, and repair if
necessary.
NG Check the following connector:
C-160
Check the harness wire between the
throttle position sensor and the
throttle valve controller, and repair if
necessary.
OK
Check the following connector:
C-160
Check the trouble symptoms.
Replace the throttle valve controller.
NG
OK
NG
OK
NG
OK
NG
OK
NG
Repair
Repair
Repair
Repair