Mitsubishi FUEL Manual page 190

13A-190
CHECK CHART FOR RESISTANCE AND CONTINUITY BETWEEN TERMINALS
Engine-ECU Harness Side Connector Terminal Arrangement
Terminal No. Inspection item
1 - 47 No. 1 injector
9 - 47 No. 2 injector
24 - 47 No. 3 injector
2 - 47 No. 4 injector
10 - 47 No. 5 injector
25 - 47 No. 6 injector
14 - 47 Stepper motor coil (A1)
28 - 47 Stepper motor coil (A2)
15 - 47 Stepper motor coil (B1)
29 - 47 Stepper motor coil (B2)
6 - 47 EGR control solenoid valve
16 - 47 Purge control solenoid valve
30 - 47 Vacuum control solenoid
valve system
<Vehicles with TCL>
31 - 47 Ventilation control solenoid
valve system
<Vehicles with TCL>
46 - Body Engine-ECU earth
earth
58 - Body Engine-ECU earth
earth
3 - 47 Left bank oxygen sensor
heater control (front)
26 - 47 Left bank oxygen sensor
heater control (rear)
4 - 47 Right bank oxygen sensor
heater (front)
27 - 47 Right bank oxygen sensor
heater (rear)
MPI <6A1> -
Troubleshooting
Normal condition (Check condition)
13 - 16 W (At 20_C)
28 - 33 W (At 20_C)
29 - 35 W (At 20_C)
30 - 34 W (At 20_C)
36 - 44 W (At 20_C)
36 - 44 W (At 20_C)
Continuity (0 W)
4.5 - 8.0 W (At 20_C)
11 - 18 W (At 20_C)
4.5 - 8.0 W (At 20_C)
11 - 18 W (At 20_C)