Mitsubishi FUEL Manual page 178

13A-178
Item Inspection Inspection contents
No. item
22 Crank D
angle sen-
sor D
D
D
24 Vehicle Drive at 40 km/h
speed sen-
sor
25 Barometric Ignition switch: ON
pressure
sensor
26 Idle posi- Ignition switch: ON
tion switch Check by operating
accelerator pedal
repeatedly
27 Power Engine: Idling
steering
fluid pres-
sure switch
28 A/C switch Engine: Idling
(when A/C switch is (when A/C switch is
ON, A/C compressor
should be operating.)
29 Inhibitor Ignition switch: ON
switch
<A/T>
MPI <6A1> -
Engine: Compare the engine
Cranking speed readings on
Tachometer: the tachometer and
Connected the MUT-II.
Engine: Idling When engine
Idle position coolant temperature
switch: ON is - 20_C
When engine
coolant temperature
is 0_C
When engine
coolant temperature
is 20_C
When engine
coolant temperature
is 40_C
When engine
coolant temperature
is 80_C
At altitude of 0 m
At altitude of 600 m
At altitude of 1,200
m
At altitude of 1,800
m
Throttle valve:
Set to idle position
Throttle valve:
Slightly open
Steering wheel
stationary
Steering wheel
turning
A/C switch: OFF
A/C switch: ON
P or N
D, 2, L or R
Troubleshooting
Normal condition
Accord
1,300 - 1,500 rpm
1,300 - 1,500 rpm
1,300 - 1,500 rpm
1,100 - 1,300 rpm
550 - 750 rpm
Approximately 40
km/h
101 kPa
95 kPa
88 kPa
81 kPa
ON
2
OFF*
OFF
ON
OFF
ON
P or N
D, 2, L or R
Inspection Reference
procedure page
No.
Code No. 13A-130
P0335
Code No. 13A-137
P0500
Code No. 13A-103
P0105
Code No. 13A-139
P0510
Code No. 13A-140
P0551
Procedure 13A-174
No. 30 No. 30
Procedure 13A-173
No. 29