Cisco Catalyst 3120 Command Reference Manual page 163

Catalyst blade switch 3120 for hp command reference

Hide thumbs Also See for Catalyst 3120:

Table of Contents

Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

Follow these guidelines when you use the interface port-channel command:

For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the

software configuration guide for this release.

This example shows how to create a port-channel interface with a port channel number of 5:

Switch(config)# interface port-channel 5

You can verify your setting by entering the show running-config privileged EXEC or show

etherchannel channel-group-number detail privileged EXEC command.

Related Commands

channel-group

show etherchannel

show running-config

If you want to use the Cisco Discovery Protocol (CDP), you must configure it only on the physical

port and not on the port-channel interface.

Do not configure a port that is an active member of an EtherChannel as an IEEE 802.1x port. If

IEEE 802.1x is enabled on a not-yet active port of an EtherChannel, the port does not join the

EtherChannel.

Assigns an Ethernet port to an EtherChannel group.

Displays EtherChannel information for a channel.

Displays the operating configuration. For syntax information, use this link to

the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command

_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to navigate to

the command.

Cisco Catalyst Blade Switch 3120 for HP Command Reference

interface port-channel