Debug Mac-Notification - Cisco Catalyst 3120 Command Reference Manual

Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands

debug mac-notification

Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification
events. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines
The undebug mac-notification command is the same as the no debug mac-notification command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
show mac
address-table
notification
OL-12248-01
debug mac-notification
no debug mac-notification
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays the MAC address notification information for all interfaces or the
specified interface.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
debug mac-notification
B-17