Switchport Voice Detect - Cisco Catalyst 3120 Command Reference Manual

switchport voice detect

switchport voice detect
Use the switchport voice detect interface configuration command on the switch stack or on a standalone
switch to detect and recognize a Cisco IP phone. Use the no form of this command to return to the default
setting.
Syntax Description
cisco-phone
full-duplex
Command History Release
12.2(40)EX
Usage Guidelines
Use this command to detect and recognize a Cisco IP phone.
Examples
This example shows how to enable detection and recognition of a Cisco IP phone on the switch:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# switchport voice detect cisco-phone
This example shows how to disable detection and recognition of a Cisco IP phone on the switch:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# no switchport voice detect cisco-phone
You can verify your settings by entering the show run interfaces interface-id privileged EXEC
command.
Related Commands
No related commands.
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-718
switchport voice detect cisco-phone [full-duplex]
no switchport voice detect cisco-phone [full-duplex]
Configure the switch to detect and recognize a Cisco IP phone.
(optional) Configure the switch to only accept a full-duplex Cisco IP phone.
Modification
This command was introduced.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-01