Cisco Catalyst 3120 Command Reference Manual page 165

Catalyst blade switch 3120 for hp command reference

Hide thumbs Also See for Catalyst 3120:

Table of Contents

Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

Valid values for port-range type and interface:

When you define a range, you must enter a space between the first entry and the hyphen (-):

interface range gigabitethernet1/0/1 -2

When you define multiple ranges, you must still enter a space after the first entry and before the

interface range gigabitethernet1/0/1 - 2, gigabitethernet1/0/1 - 2

You cannot specify both a macro and an interface range in the same command.

You can also specify a single interface in port-range. The command is then similar to the interface

interface-id global configuration command.

For more information about configuring interface ranges, see the software configuration guide for this

This example shows how to use the interface range command to enter interface-range configuration

mode to apply commands to two ports:

Switch(config)# interface range gigabitethernet1/0/1 - 2

Switch(config-if-range)#

This example shows how to use a port-range macro macro1 for the same function. The advantage is that

you can reuse macro1 until you delete it.

Switch(config)# define interface-range macro1 gigabitethernet1/0/1 - 2

Switch(config)# interface range macro macro1

Switch(config-if-range)#

vlan vlan-ID - vlan-ID, where VLAN ID is from 1 to 4094

gigabitethernet stack member/module/{first port} - {last port}, where module is always 0

tengigabitethernet stack member/module/{first port} - {last port}, where module is always 0

For physical interfaces:

stack member is the number used to identify the switch within the stack. The number ranges

from 1 to 9 and is assigned to the switch the first time the stack member initializes.

module is always 0

the range is type stack member/0/number - number (for example, gigabitethernet1/0/1 - 2)

port-channel port-channel-number - port-channel-number, where port-channel-number is from 1

When you use the interface range command with port channels, the first and last port

channel number in the range must be active port channels.

Cisco Catalyst Blade Switch 3120 for HP Command Reference

interface range