Debug Backup - Cisco Catalyst 3120 Command Reference Manual

debug backup

debug backup
Use the debug backup privileged EXEC command to enable debugging of the Flex Links backup
interface. Use the no form of this command to disable debugging.
Syntax Description
all
errors
events
vlan-load-
balancing
Command Default
Backup interface debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines The undebug backup command is the same as the no debug backup command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-4
debug backup {all | errors | events | vlan-load-balancing}
no debug backup {all | errors | events | vlan-load-balancing}
Display all backup interface debug messages.
Display backup interface error or exception debug messages.
Display backup interface event debug messages.
Display backup interface VLAN load balancing.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
OL-12248-01