Debug Sw-Vlan Ifs - Cisco Catalyst 3120 Command Reference Manual

debug sw-vlan ifs

debug sw-vlan ifs
Use the debug sw-vlan ifs privileged EXEC command to enable debugging of the VLAN manager IOS
file system (IFS) error tests. Use the no form of this command to disable debugging.
Syntax Description
open {read | write}
read {1 | 2 | 3 | 4}
write
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines The undebug sw-vlan ifs command is the same as the no debug sw-vlan ifs command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
When selecting the file read operation, Operation 1 reads the file header, which contains the header
verification word and the file version number. Operation 2 reads the main body of the file, which
contains most of the domain and VLAN information. Operation 3 reads type length version (TLV)
descriptor structures. Operation 4 reads TLV data.
Related Commands Command
show debugging
show vlan
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-82
debug sw-vlan ifs {open {read | write} | read {1 | 2 | 3 | 4} | write}
no debug sw-vlan ifs {open {read | write} | read {1 | 2 | 3 | 4} | write}
Display VLAN manager IFS file-open operation debug messages. The
keywords have these meanings:
• read—Display VLAN manager IFS file-read operation debug messages.
• write—Display VLAN manager IFS file-write operation debug messages.
Display file-read operation debug messages for the specified error test (1, 2, 3,
or 4).
Display file-write operation debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
OL-12248-01