HP Data Protector A.06.11 Command Line Interface Manual page 398

This parameter corresponds to the Rescan option in the Data Protector GUI.
SANSTABLEADDRESSING
This parameter corresponds to the Automatically discover changed
SCSI address option in the Data Protector GUI.
-library_template LibraryTemplateFileName
This option alters the default configuration of the library. You can alter the default
configuration of the library only at the initial configuration. After the library is
configured, you can no longer change the configuration of the library using the
sanconf command.
The LibraryTemplateFileName must be an ASCII file with one parameter
specified per line.
Library template supports the following parameters:
BARCODEREADER
This parameter corresponds to the Barcode reader support option in the
Data Protector GUI.
BUSYDRIVETOSLOT
This parameter corresponds to the Busy drive handling: Eject medium
option in the Data Protector GUI.
BUSYDRIVETOMAILSLOT
This parameter corresponds to the Busy drive handling: Eject medium
to mail slot option in the Data Protector GUI.
SANSTABLEADDRESSING
This parameter corresponds to the Automatically discover changed
SCSI address option in the Data Protector GUI.
-[no_]multipath
By default or if the -no_multipath option is given, sanconf does not configure
multipath devices – a separate logical device will be configured for each path.
When reconfiguring a multipath library as a non-multipath library, only one path
is created. Multipath drives contained inside a multipath library are not changed,
while new drives are created. Only non-multipath drives are modified.
If the -multipath option is used, sanconf configures all paths pointing to a
single physical device as a single multipath device.
When reconfiguring a non-multipath library as a multipath library, the library
control host is used as the first path. Non-multipath drives are not changed or
removed. Instead, new multipath drives are created. Only multipath drives are
modified.
-sanstableaddressing
398