HP Data Protector A.06.11 Command Line Interface Manual page 397

1 DDT
2 QIC
3 EXA
4 AIT
5 3480
6 RDSK
7 REGFILE
8 9840
9 TAPE
10 DLT
11 D3
12 3590
13 LTO
14 SDLT
15 VXA
16 DTF
17 9940
18 SAIT
19 3592
When drives in the library are not of the same type as specified, an error is
reported.
-drive_template DriveTemplateFileName
This option alters the default configuration of each tape device added to the
library. You can alter the default configuration of the library only at the initial
configuration. After the library is configured, you can no longer change the
configuration of the library using the sanconf command.
The DriveTemplateFileName must be an ASCII file with one parameter
specified per line.
Drive template supports the following parameters:
VERIFY
This parameter corresponds to the CRC Check option in the Data Protector GUI.
CLEANME
This parameter corresponds to the Detect dirty drive option in the Data
Protector GUI.
RESCAN
Command line interface reference 397