HP Data Protector A.06.11 Command Line Interface Manual page 217

VSS_DISK_ARRAY_XP_OPTIONS
-copy_back
Performs resynchronization of the disk pair, copying data from the target volume
(backup disk) to the source volume. This option must be specified if the data was
backed up with VSS provider in the resync mode.
-no_retain_source
Deletes the source volume during restore. This option must be specified if the
data was backed up with VSS provider in the resync mode since there is no
possibility to retain the source during re-synchronization of replica and source
disk.
-no_diskarray_wait
If this option is specified, the source volume is immediately available while the
synchronization or copy process is running in the background (quick restore).
The SSE Agent does not wait for the synchronization or copy process to complete.
If this option is not specified, there is a 60–minute delay before the background
processes can run.
VSS_EXCHANGE_SPECIFIC_OPTIONS
-exch_check
Performs the consistency check of the Microsoft Exchange Server database
replicated datafiles. The Microsoft Exchange Server database backup is
considered as successful only if the consistency check succeeds. Use this option
if consistency check was not performed during backup.
-exch_throttle Value
Throttles down the consistency check to lessen impact on restore performance.
Set the number of input/output operations, after which the check is stopped for
one second.
VSS_EXCHANGE_2007_SPECIFIC_OPTIONS
-appsrv ClientName
Specifies the system to which the components are restored. If not specified, the
components are always restored to the server from where they were backed up.
Note that all objects in one restore session must be restored to the same system.
-target_tree TargetStoreName
Specifies the target component to which the source component will be restored
and enables you to restore a subcomponent to a different component than the
one from which it was backed up. This option can be used only once for each
-tree option and cannot be specified together with -exch_RSG.
Command line interface reference 217