HP Data Protector A.06.11 Command Line Interface Manual page 227

Selects the SAP R/3 options for instant recovery.
-recover {now | time Time | logseq LogSeqNum
thread ThreadNum | SCN Number}
Selects the point in time to which the database is recovered. The following options
are available:
now
All existing archive logs are applied.
time MM/DD/YY hh:mm:ss
Specifies an incomplete recovery. Archive logs are applied only to a specific
point in time.
logseq LogSeqNum thread ThreadNum
Specifies an incomplete recovery. Archive logs are applied only to the
specified redo log sequence and thread number.
SCN Number
Specifies an incomplete recovery. The archive logs are applied only to the
specified SCN number.
-open
Opens the database after recovery.
-resetlogs
Resets the logs after the database is opened. Available only if the -open option
is specified. This option is not available if the -recovery option is set to now.
The following are recommendations on when to reset the logs.
Always reset the logs:
- After an incomplete recovery, that is if not all archive redo logs will be applied.
- If a backup of a control file is used in recovery.
Do not reset the logs:
- After a complete recovery where a backup of a control file is not used in
recovery.
- If the archive logs are used for a standby database. If you must reset the archive
logs, then you have to recreate the standby database.
-user UserName -group GroupName
Specifies the username and group name of the account under which Data
Protector starts instant recovery. Required only for UNIX clients.
-appname ApplicationDatabaseName
Name of the backed up database.
-parallelism Number
Command line interface reference 227