HP Data Protector A.06.11 Command Line Interface Manual page 117

-list -purge
Lists all virtual disks (source or target volumes) that are marked for purging in the
SMISDB.
-purge
Runs SMI-S Agent to perform the SMISDB purge operation that attempts to remove
the virtual disks (source or target volumes) that could not be deleted although
they should be. These elements are marked for purging, and the information
about them is stored in the SMISDB.
Used together with the -force option, the command forces removal of the
elements marked for deletion even if they are presented to the hosts.
If the -host hostname option is specified, you can choose another location
to start the SMISDB purge operation. Use this option if the systems, involved in
a backup session, are no longer available, thus allowing redirection to another
systems that have the SMI-S Agent installed.
-delete -session SessionID
Deletes a specific backup session (replica), identified by the session ID, on the
disk array, and deletes information about the replica from the SMISDB.
-delete -datalist DatalistName
Deletes all backup sessions based on a specific backup specification (a replica
set) on the disk array, and deletes information about the replica set from the
SMISDB. Once excluded from use by Data Protector, sessions cannot be deleted.
-delete -preview
If used with the -preview option, the command does not delete anything, but
lists replicas/replica sets that will be deleted if -delete -session sessionID
or -delete -datalist DatalistName commands are run.
-delete -force
Forces deletion of the replicas even if they are presented to hosts.
-delete -host hostname
Sets another location to start the deletion. Use this option if the systems, involved
in a backup session, are no longer available, thus allowing redirection to another
systems that have the SMI-S Agent installed.
-sync
Synchronizes the persistent data in the SMISDB with the EVA storage system. If
any target volume in a replica is missing on the EVA storage system, the whole
backup session that created this replica is deleted from the database. Use this
option if you deleted some replicas directly through the SMI-S EVA provider.
If run with the -preview option, the command does not delete anything, but
lists the target volumes that would be deleted if omnidbsmis -sync is run.
Command line interface reference 1 17