HP Data Protector A.06.11 Command Line Interface Manual page 390

OPTIONS
-version
Displays the version of the omnisv command.
-help
Displays the usage synopsis for the omnisv command.
-start
Starts the Data Protector services (on Windows) and adds the omnitrig
command to the cron table, thus configuring it as a cron job (on UNIX).
-stop
Stops the services (on Windows) and removes the omnitrig command from
the cron table (on UNIX).
-status
Displays the status and PID of the services.
-start_mon
Waits in loop until the CRS, MMD, UIProxy, KMS and RDS services are up
and running. If any daemon or service stops, omnisv exits with an exit code 1.
Exit code 0 means that all relevant Data Protector daemons/services are up and
running, whereas the exit code 1 means that at least one of the relevant Data
Protector daemons or services is not running.
NOTES
On Windows systems, only the users in the Data Protector admin group can execute
this command. On HP-UX and Solaris systems, only the root user can execute this
command. It is not possible to start or stop services on a cluster using this command.
SEE ALSO
omnicc(1), omnicellinfo(1), omnicheck(1M), omnidlc(1M), omniinstlic(1M)
390