HP Data Protector A.06.11 Command Line Interface Manual page 145

Specifies the output backup device - the device used to create a copy of the
medium (target medium). You can specify only one slot. For VLS smart copies,
the output backup device is the name of the VTL that will be used for
automigration. The -slot parameter takes the barcode value of the target tape.
-from BackupDevice [-src_slot Slot...]
Specifies the input backup device — the device which is used as a source. You
can specify only one slot. The -src_slot parameter takes the barcode value
of the source tape.
-ams
Specifies that the VLS smart copy is to be created.
-from VLS_SMART_COPY
Specifies that VLS is the input backup device.
-src_slot SourceTapeBarcode
Specifies the barcode of the source tape.
-copy VirtualTapeLibrary
Specifies the name of the VTL used for automigration.
-slot TargetTapeBarcode
Specifies the barcode of the target tape.
-pool PoolName
Specify the poolname to which the copy of the medium is added. By default the
medium is added to the source media poolname. This option is mandatory if the
-ams option is specified, since no devices exist where a default pool can be
derived from.
-location Location
Specifies the location of the media, when you keep them out of the library. Used
for the vaulting purposes.
-force
Overwrites the data on the target medium even if this data is still protected by
the Data Protector media management system. Note that this option must be used
with an unprotected medium as well.
-size SpecSize
This option specifies the size of the target medium.
-encrypt
This option turns on hardware encryption on all destination drives.
-eject
Ejects the target medium from the drive after the medium is copied.
Command line interface reference 145