HP Guardian Errors Manual page 53

Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent. If this problem persists and a data communications
process is involved, obtain a trace and submit it to your service provider.
163 (%243)
Cause Either an end-of-transmission (EOT) message was received while the procedure was waiting
for a line bid or for a message, or the power at the auto-call unit was off.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent. If this problem persists and a data communications
process is involved, obtain a trace and submit it to your service provider.
164 (%244)
Cause Either a disconnect was received, a send disconnect call was issued while a request was
outstanding, or the data line was busy. This error message also occurs when the specified number
of retries for an Expand send message are used up.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent.
165 (%245)
Cause A reverse interrupt (RVI) was received, or the data line was not occupied after setting the
call request.
Effect The procedure sets the error code and returns without performing the requested operation.
Corrective action is device dependent. If this problem persists and a data communications process
is involved, obtain a trace and submit it to your service provider.
166 (%246)
Cause An inquiry (ENQ) was received, or the auto-call unit failed to set "present next digit."
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent. If this problem persists and a data communications
process is involved, obtain a trace and submit it to your service provider.
167 (%247)
Cause Either an end-of-transmission (EOT) message was received in response to a line bid or
selection, or "data set status" was not set after dialing all digits.
Effect The procedure sets the error code and returns without performing the requested operation.
EOT received (device type: 7.0, 7.1, 7.2,
7.3, or 7.8) or power at autocall unit is
off (device type: 7.56 or 11).
Disconnect received (device type: 7.0, 7.1,
10, 11, 61, or 63) or data line is occupied
(device type: 7.56 or 11).
RVI received (device type: 7.0, 7.1,
7.2, or 7.3) or data line not occupied
after setting call request
(device type: 7.56 or 11).
ENQ received (device type: 7.0, 7.1,
7.3, or 7.9) or auto call unit failed
to set present-next-digit
(device type: 7.56 or 11).
EOT received on line bid (device type: 7.0,
7.1, 7.3, or 7.8), or data-set-status not
set (device type: 7.56 or 11)
Error Code Descriptions 53