HP Guardian Errors Manual page 30

Cause Insufficient physical memory was available to perform the specified operation.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Wait, then try again. If the problem persists, check the system for processes that use too
much locked memory; run MEASURE to help determine which processes are locking memory.
37
Cause Insufficient physical memory was available to perform the specified I/O operation. This
message is returned for a privileged operating system call.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Wait, then try again. Check the system for processes that use too much locked memory;
run MEASURE to help determine which processes are locking memory. If the problem persists,
contact your service provider.
38
Cause Program running on a NonStop system specified an operation available only on a NonStop
1+ system.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Recode the application to eliminate the invalid operation.
39
Cause A sync ID was encountered that is older than the current sync ID minus the sync depth.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Recovery is application dependent.
40
Cause One of the following occurred:
A call to AWAITIO[X] or FILE_COMPLETE_ did not finish within the time specified by its timelimit
parameter.
A message was added to the caller's queue (such as a BREAK message) while the procedure
PROCESS_DEBUG_ or DEBUGPROCESS was being used.
Effect For AWAITIO[X], if 0D was specified for the time limit (completion check) or if - 1 was specified
for the file number (wait for completion of an operation on any file), the operation did not finish.
If a nonzero time limit and a particular file were specified, the operation timed out and was
automatically canceled; it is considered completed.
For FILE_COMPLETE_, this error is only returned when a time limit other than - 1 D (wait indefinitely)
was specified and the operation did not finish.
The requested action might have been performed.
30 File-System Errors
(%45) I/O process is unable to lock physical
memory. (device type: any except 2)
(%46) Attempt to perform operation on wrong
type of TNS system. (device type: any except 2)
(%47) The server process received a request with
a sync ID older than the set of saved
replies. (device type: 0)
(%50) The operation timed out. AWAITIO[X] or
FILE_COMPLETE_ did not complete within
the time specified by its <time-limit> parameter.