HP Guardian Errors Manual page 57

Recovery Corrective action is application dependent.
183 (%267)
Cause The file-system procedure call issued by the primary or secondary logical unit could not be
performed because the logical-unit-to-logical-unit session associated with the specified device
(filenum) no longer exists.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Close, then reopen the process.
187 (%273)
Cause CONTROL 26 was previously issued to complete all outstanding requests from this
application.
Effect All pending and active READ, WRITE, and WRITEREAD requests are completed, and no
data is transferred.
Recovery Recovery is application dependent.
188 (%274)
Cause CONTROL 26 was previously issued to complete all outstanding requests from this
application.
Effect The state of the session is suspect.
Recovery Recovery is application dependent.
189 (%275)
Cause CONTROL 26 was previously issued to complete all outstanding requests from this
application.
Effect The requesting program concludes that the actions initiated by a READ, WRITE, or WRITEREAD
request are in progress, and the response that would have been returned is not yet available.
Recovery Recovery is application dependent. A generic read operation will retrieve the response
when the response is available.
190 (%276)
Cause A hardware error occurred and persisted through several retries of the operation. A problem
exists with either the device or its controller. The error might be caused by a termination condition
that was not expected.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent. If this problem persists and a data communications
process is involved, obtain a trace and submit it to your service provider.
191 (%277)
SNA session has ended.
(device type: 14.2)
Operation returning with no useful data
Damage to logical flow of events.
Response not yet available.
Device error; hardware problem.
(device type: any except 2)
Device power on (device type: 5),
or terminal reset (device type: 6).
Error Code Descriptions 57