HP Guardian Errors Manual page 58

Cause The device power was switched off, perhaps due to power failure, then was switched back
on during this operation.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Corrective action is device dependent.
192
Cause The system operator was running diagnostic programs on the specified device.
Effect The procedure sets the error code and returns without performing the requested operation.
Recovery Wait, then try again.
193
Cause The operating system could not do one of the following:
Locate the microcode files for a downloadable controller
Read either of the microcode files because of disk file errors
Download from the microcode files because they are not formatted properly
Effect The procedure sets the error code and returns without performing the requested operation.
The operator message MICROCODE LOADING FAILURE (console message 100, EMS operator
message 100, or DISK operator message 5035) is displayed twice, once for the primary file and
once for the backup.
Recovery See the Operator Messages Manual for information on correcting this error.
194
Cause A MEDIACOM REJECT TAPEMOUNT command (on G-series systems) was issued to reject
a mount request or to request use of a drive for an unlabeled tape.
Effect The open fails.
Recovery Informative message only; no corrective action is needed.
195
Cause On a system with tape label processing enabled, the named process $ZSVR was not running
when a tape operation was requested to open a tape file.
Effect No tape operation is allowed.
Recovery Start $ZSVR. For additional information, see the appropriate system operator's guide.
196
Cause The label record on the tape volume was incorrect or missing or a DEFINE attribute value
did not match the value for that attribute recorded in the tape label.
Effect Access to the tape file is denied.
58 File-System Errors
(%300) Device in diagnose mode; system operator
running diagnostics. (device type: 3, 4,
5, or 6)
(%301) Invalid or missing microcode file.
(device type: any except 3)
(%302) Device use or mount request rejected by operator.
(device type: 4)
(%303) Operation requires use of $ZSVR but it is
not running; tape operation is not
allowed. (device type: 4)
(%304) A tape label record is missing
or incorrect. (device type: 4)