HP Guardian Errors Manual page 251

sysmsg[17] = The subsystem number
sysmsg[18] = The subsystem version
sysmsg[19] = The length of text in bytes
sysmsg[20] FOR n = Up to 80 bytes of text
If the operating system deletes the process name from the process-pair directory, it sends the
following message. This message indicates that neither member of the process pair exists.
sysmsg[0]
sysmsg[1] FOR 3
sysmsg[4]
sysmsg[5]
sysmsg[19])
sysmsg[6] FOR 4
sysmsg[10]
sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4 = Subsystem organization (8 bytes);.
sysmsg[17] = Subsystem number
sysmsg[18] = Subsystem version
sysmsg[19] = Length of text in bytes
sysmsg[20] FOR n = Text (up to 80 bytes)
If an external process caused the termination, the abend message is changed as follows:
sysmsg[11] = Completion code defaults to 6
sysmsg[12] = Creator access ID
sysmsg[13] FOR 4 = Process ID of the process that caused
If a trap is encountered, the abend message is changed as follows:
sysmsg[11]
sysmsg[12]
sysmsg[13] FOR 4
sysmsg[17]
sysmsg[18]
sysmsg[19]
sysmsg[20] FOR 76 = Is the following text:
TRAP NO=nn, S=nnnnnn, CS=nn, P=nnnnnn,
ENV=nnnnnn, L=nnnnnn, OCT P=nnnnnnnn
For information about the completion codes, refer to
Response The response, if any, is application dependent.
-8 CHANGE IN STATUS OF NETWORK NODE
Cause (C-series-format system message only) The process that was running on a system that is part
of a network enabled receipt of remote status-change messages by passing "1" as a parameter
to the MONITORNET procedure.
Format The layout of the received message described in terms of an array of words is:
sysmsg[0] = -8
sysmsg[1].<0:7> = System number
sysmsg[1].<8:15> = Number of processors
sysmsg[2] = Current processor-status bit mask
sysmsg[3] = Previous processor-status bit mask
for HP products, this is HP
= -6
= The name of the deleted process
= -1
= The header size (header ends at
= Process processor time in microseconds
(a FIXED value)
= The job ID; 0 if process has no GMOM
= The completion code
= Termination information; 0 if the user
did not supply information
for HP products,this is HP
the termination
= Completion code is -1
= Termination information is 0
= Subsystem organization is 4 words of
blanks
= Subsystem number is 0
= Subsystem version is 0
= Length is 76 bytes of text
Table 15 (page 260).
Message Descriptions 251