HP Guardian Errors Manual page 46

If the cause of the error is that the operation tried to use a CLASS TAPE DEFINE when this DEFINE
class was not supported, you must either use a CLASS TAPECATALOG DEFINE in the operation
or enable TAPE DEFINEs. See the DSM/Tape Catalog User's Guide for more information.
If the error is due to an incompatibility among the DENSITY, TAPEMODE, and DEVICE attributes
of a TAPE DEFINE or TAPECATALOG DEFINE, you must change the DEFINE in accordance with
the following rules.
Specify the DENSITY attribute only when the tape drive to be used supports open reel tape
volumes.
Specify the TAPEMODE attribute only when the tape drive to be used supports cartridge tape
volumes.
If a particular tape drive is to be used, specify the DEVICE attribute using a tape drive that
matches the DENSITY or TAPEMODE attribute.
Never specify both the DENSITY and TAPEMODE attributes in the same DEFINE.
114
Cause The line will not come up.
Effect X.25 aborts the request; an event message is sent to the EMS collector process.
Recovery Fatal error; no recovery is possible. Determine the error from a trace of the code and try
again. If the problem is still not apparent, submit the trace, log file, CONFLIST, subunit, and line
configuration to your service provider.
115
Cause A reset attempt timed out.
Effect X.25 aborts the request; an event message is sent to the EMS collector process.
Recovery Fatal error; no recovery is possible. Determine the error from a trace of the code and try
again. If thTPSEC.fm, FMT 2.4.3, 08-04-2003e problem is still not apparent, submit the trace, log
file, CONFLIST, subunit, and line configuration to your service provider.
119
Cause The file-system error number is greater than 255 for NEWPROCESS or
NEWPROCESSNOWAIT. See
for an explanation of the information returned in the errinfo parameter.
Effect File-system error numbers greater than 255 can be used when a buffer larger than 8 bits is
available.
Recovery Determine the actual file-system error and take the appropriate action. Corrective action
is application dependent. For NEWPROCESS and NEWPROCESSNOWAIT, these file-system error
numbers are returned in the errinfo parameter.
120
46 File-System Errors
(%162) X25 Network problem - RESTART FAILURE.
(device type: 61)
(%163) X25 Network problem - RESET FAILURE.
(device type: 61)
(%167) Error code value was too large to fit
into an 8-bit buffer; file-system error
number is greater than 255.
"NEWPROCESS AND NEWPROCESSNOWAIT Errors" (page
(%170) Data parity error, or attempt to access
a tape whose density is higher than the
switch setting on the tape drive.
(device type: any except 2)
141),