Related Reading; Notation Conventions; General Syntax Notation - HP Guardian Errors Manual

"SEGMENT_ALLOCATE_ and SEGMENT_ALLOCATE64_ Errors" (page
error codes and error lists produced by the SEGMENT_ALLOCATE_ procedure.
"USESEGMENT Errors" (page
procedure.
"SEGMENT_USE_Errors" (page
SEGMENT_USE_ procedure.
Section 14,"Subsystem Programmatic Interface (SPI) Errors" (page
codes issued by the SPI procedures and the error lists associated with those procedures.
"EDITREAD and EDITREADINIT Errors" (page
and EDITREADINIT procedures.
"IOEdit Errors" (page
These errors include file-system errors that have specific meaning for IOEdit.
"Formatter Errors" (page
procedures.
"INITIALIZER Errors" (page
procedure.
"Interprocess Command Interpreter Messages" (page
system messages that an application can receive through its $RECEIVE file.
"System Messages" (page
can receive through its $RECEIVE file.
"Traps and Signals" (page
lists used to report trap and signal conditions.
"Brief OSS Error Information" (page
Services (OSS) errors.

Related Reading

This manual assumes that you are familiar with the HP system architecture and the NonStop
operating system. The following manuals provide information about the hardware architecture and
the operating system:
Introduction to Tandem NonStop Systems
The introductions and system description manuals for individual HP NonStop systems
While using this manual, you might need to refer to the following related programming manuals.
Guardian Programmer's Guide
Guardian Procedure Calls Reference Manual
Guardian Programming Reference Summary
Open System Services System Calls Reference Manual
Open System Services System Calls Reference Manual

Notation Conventions

General Syntax Notation

The following list summarizes the notation conventions for syntax presentation in this manual.
UPPERCASE LETTERS. Uppercase letters indicate keywords and reserved words; enter these items
exactly as shown. Items not enclosed in brackets are required. For example:
MAXATTACH
207), describes the error list associated with the USESEGMENT
209), describes the error list associated with the
220), describes the errors returned by the EDITREAD
222), describes the error messages returned by the IOEdit procedures.
228), describes the error codes produced by the FORMATDATA[X]
230), describes the error messages produced by the INITIALIZER
16), describes the operating-system messages that an application
17), describes trap codes, TNS/R native signals, and the error
279), describes how to find information on Open System
202), describes the
211), describes the error
233), describes the command interpreter
Related Reading 1 1