Table of Contents
Advertisement
Chapter 3. About the D-FIELD
Changing the volume of the parts (X-FADER)
The volume or pan of two parts can be controlled simultaneously.
Display
TYPE
X
Y
Changing the D-FIELD settings (p. 22)
As an alternate way to select the part that will be controlled, you can hold down [X-FADER] and press a part button while making
X or Y settings. (At this time, the selected part button will blink.)
When TYPE is "LEVEL," it is not possible for the volume to become louder than the volume setting of the pattern.
Making the sound change over time (ASSIGN 2: ENVELOPE)
fig.ENV—
You can control the time-variant change in pitch, tone, and volume of the current part.
Display
TYPE
none
X
Y
Changing the D-FIELD settings (p. 22)
About the envelope
These parameters specify how the pitch, filter, or amp will change over time. As shown in
the diagram below, this allows you to specify how change will occur from the beginning to
the end of the sound.
fig.Envelope
Pitch
Filter (Cutoff Frequency)
Level
+
Attack
Decay
0
Note On
34
Explanation
Specify whether you will control volume or pan.
Select the part that will be affected when you move your
finger to left or right.
Select the part that will be affected when you move your
finger upward or downward.
Explanation
none
Select the parameter that will be
affected when you move your
finger to left or right.
Select the parameter that will be
affected when you move your
finger upward or downward.
Release
Time
Sustain
Note Off
Setting
LEV (LEVEL), PAN
P-r, P-1–P-7
* It is not possible to select
the same part for both X
and Y.
Setting
none
OFF,
PITCH DEPTH, PITCH ATTACK TIME, PITCH DECAY TIME,
PITCH SUSTAIN LEVEL, PITCH RELEASE TIME, FILTER DEPTH,
FILTER ATTACK TIME, FILTER DECAY TIME,
FILTER SUSTAIN LEVEL, FILTER RELEASE TIME,
AMP ATTACK TIME, AMP DECAY TIME, AMP SUSTAIN LEVEL,
AMP RELEASE TIME
* It is not possible to select the same parameter for both X and Y.
Advertisement
Table of Contents
