Table of Contents
Advertisement
Screen
Parameter
BALANCE
(Effect Balance)
OUTPUT LEVEL
24. Gate Reverb (Sharply Cut the Reverberation)
fig.MFXGTR
This is a type of reverb, in which the reverberation is cut off before the natural completion of its decay.
Screen
Parameter
TYPE
(Gate Reverb Type)
TIME
(Gate Reverb Time)
BALANCE
(Effect Balance)
OUTPUT LEVEL
25. Isolator (Cuts Off a Specific Range)
fig.MFXISO
An equalizer which cuts the volume greatly, allowing you to add a special effect to the sound by cutting the volume in varying
ranges. The Isolator parameters are, in general, effective when applied to the following musical instruments.
• LOW:
Bass drums and basses
• MID:
Vocals and the like
• HIGH:
High-pitched musical instruments such as cymbals
Screen
Parameter
LOW GAIN
MID GAIN
HIGH GAIN
PAN
LEVEL
Chapter 4. Applying Effects to the Sound (Effects)
Explanation
Specifies the volume balance be-
tween the original sound and the
reverberation.With a setting of
"0," no reverb sound will be out-
put.
Specifies the output volume from
the reverb effect.
Explanation
Select one of the following
four basic types of gated re-
verb.
Specifies the time from when
the reverberation begins un-
til it ends.
Specifies the volume balance
between the original sound
and the reverberation. With
a setting of "0," no reverb
sound will be output.
Specifies the output volume
of the Gate Reverb effect.
Explanation
Specifies the amount of low-frequency range to be cut.
Specifies the amount of mid-range to be cut.
Specifies the amount of high-frequency range to be cut.
Specifies the stereo position of the sound output from the Isola-
tor.
Determines the loudness output from the Isolator.
Value
0–100 (%)
0–127
Value
NORMAL (normal gated reverb),
REVERSE (reverse-playback reverb),
SWEEP1 (the reverberation will sweep from right to left.),
SWEEP2 (the reverberation will sweep from left to right)
5–330
0–100 (%)
0–127
Y
X
Y
Value
0–127
X
0–127
0–127
Y
L64–R63
0–127
57
Advertisement
Table of Contents
