Scope Set mode (Continued)
1 Max Hold
This item turns the peak level holding function ON or
OFF.
2 Scope Size
This item toggles the scope size setting between
normal and wide.
3 FAST Sweep
This item selects the sweep speed setting.
4 FAST Sweep Sound
This item sets the monitoring sound level for fast
sweeping.
■ Preamp and attenuator
The preamp amplifies received signals in the
receiver input (front end) circuit to improve the S/N
ratio and sensitivity. Turn this function ON when
receiving weak signals.
The attenuator prevents a strong undesired signal
near the desired frequency or near your location,
such as from a broadcast station, from causing
distortion or spurious signals.
Push [P�AMP/ATT] momentarily to turn the preamp
ON or OFF; hold down for 1 second to turn the
attenuator ON.
• "
" appears when the preamp is ON; "
appears when the 12 dB attenuator is ON.
• Only one of these functions can be activated at a time.
FUNCTIONS FOR RECEIVE
ON
Peak hold is turned ON.
(default)
Normal
Normal size is selected.
(default)
Continuous
[ F - 4
S P D ]
P u s h
momentarily to toggle the
sweep speed Fast and Slow
continuously. (default)
-10dB :
Monitoring sound is set 10 dB smaller than
normal sound. (default)
:
Same as normal sound.
0dB
:
No sound comes out while fast sweeping
OFF
[P.AMP/ATT]
"
momentarily
OFF
Peak hold is turned OFF.
Wide
Wide size is selected.
1 Sweep
O n e Fa s t s p e e d sw e e p
occurs each time [F-4 SPD]
is pushed momentarily.
"
" or "
" appears.
momentarily
1 sec.
5
5
.
72