D Manual Notch Function; D Manual Notch Filter Set Mode - Icom IC-7000 Instruction Manual

5
FUNCTIONS FOR RECEIVE

D Manual notch function

The manual notch function can be used in SSB, CW,
RTTY and AM modes.
➥ Push [MNF/ADJ] momentarily to turn the manual
notch function ON or OFF.
• " " appears when manual notch function is in use.
• Set the frequency for manual notch filtering via the
manual notch filter Set mode. (shown below)
• Even when both of the manual notch filters, "NF1"
and "NF2," are set to OFF in the manual notch filter
Set mode, "NF1" is automatically turned ON if the
manual notch function is ON.

D Manual notch filter Set mode

q Hold down [MNF/ADJ] for 1 second to enter the
manual notch filter Set mode.
w Push [F-2 NF1] or [F-3 NF2] to select the
desired filter ON or OFF.
e Rotate [DIAL] to adjust the selected filter
frequency.
• Push [F-4 NW] to toggle the filter width from narrow,
middle and wide.
r Push [MNF/ADJ] (or push [Z(
the manual notch filter Set mode.
81
)]) to exit
menu/grp
Appears
[MNF/ADJ]
[MNF/ADJ]
[MENU/GRP] [F-2] [F-3] [F-4]
While adjusting the manual notch filter, noise may
be heard. This comes from the DSP unit and does
not indicate an equipment malfunction.
[DIAL]