Basic Operation; When First Applying Power (Cpu Resetting); D Menu Resetting (M-1); Initial Settings - Icom IC-7000 Instruction Manual

3

BASIC OPERATION

■ When first applying power (CPU resetting)

B e fo r e f i r s t a p p l y i n g p o w e r, m a ke s u r e a l l
connections required for your system are complete
by referring to Chapter 2. Then, reset the transceiver
using the following procedure.
Resetting CLEARS all programmed contents in
memory channels and returns default values in
Set mode.
q Make sure the transceiver power is OFF.
w While holding down [Y(
push [PWR] to start resetting.
• The internal CPU is reset.
• The display changes to 'ALL CLEAR,' 'RF power 100%'
and 'Initial frequency and Mode' as shown at right.

D Menu resetting (M-1)

If you can't figure out how to return to menu M-1:
While holding down either [Y (
( )], turn power ON.
menu/grp
• The other groups are also reset to S-1 or G-1(Scope) at
this time.

■ Initial settings

After resetting the transceiver, set controls and
switches as shown in the diagram below.
CCW : counterclockwise
[AF]: Max. CCW
[POWER]: OFF
[PBT]: Center
(Hold down for 1 sec.)
Turn power ON, then check the display. If any of the
following indicators appear, turn them OFF as follows:
• Tuning step indicators,
Push [TS].
• MHz tuning step indicator,
Push [TS]
• 1 Hz frequency readout (SSB, CW or RTTY):
Hold down [TS].
• Preamp indicator,
Push [P�AMP/ATT]
• Attenuator indicator,
Push [P�AMP/ATT]
25
)] and [Z(
band band
)] or [Z
menu/grp
, (SSB, CW or RTTY):
Z
, (FM, WFM or AM):
Z
:
:
[PWR]
)],
[PWR]
[MENU/GRP]
i7000
ALL CLEAR
USB
VFO A
S1 3 5 7 9 20 40 60dB
P 5 10
O
M1 SPL A/B XFC
The transceiver's
• Noise blanker indicator,
initial frequency and mode
Push [NB/ADJ]
• Noise reduction indicator,
Push [NR/LEV]
• Manual notch indicator,
Push [MNF/ADJ]
• Auto notch indicator,
Push [ANF/• REC]
• Memory mode indicator, MEMO:
Use [F-4 V/M] in the M-2 menu (p. 27).
• Split indicator,
Use [F-1 SPL] in the M-1 menu (p. 89).
The transceiver's
initial frequency and mode
[RF/SQL]: Center
[PBT/M-ch/RIT]: PBT
(indicator lights)
RF Power
100%
[LOCK]: OFF
BLANK
CH
:
:
:
:
:
[Y]
[Z]