D Fix Mode - Icom IC-7000 Instruction Manual

D Fix mode

Displays signals within the specified frequency
range. The selected band conditions can be
observed at a glance when using this mode.
q Set a mode and frequency.
w Select G-1 (Scope).
• Hold down [MENU/GRP] for 1 second once or twice
to select the menu group G (Graphic).
• Push [MENU/GRP] momentarily one or more times
to select the menu G-1 (Scope).
e Push [F-3 FIX] momentarily to select the fix
mode.
• "O" and readout frequency indicator appear when the
fix mode is selected.
r Push [F-4 SPD] momentarily to select the sweep
speed.
• "≈" or "≈≈" appears when Slow speed or Fast speed
is selected, respectively.
t Push [F-1 SPN] one or more times to select the
desired steps.
• ±10, 25, 50, 100 and 250 kHz are available.
• Hold down [F-1 SPN] for 1 second to select the ±10
kHz step.
• "<" or ">" indicates when the displayed frequency is
out of range. The scope center position can be set to
the displayed frequency by holding down [F-3 FIX]
for 1 second.
• The simple band scope operates in the peak
level hold mode. Peak levels are displayed in the
background of the current spectrum in a different
color until the receive frequency changes. This can be
cleared by holding down [F-2 HLD] for 1 second, or
deactivated in the scope Set mode. (p. 72)
y Push [F-2 HLD] to freeze the current spectrum
display.
• "H" appears while the function is in use.
FUNCTIONS FOR RECEIVE
[F-1]
[MENU/GRP] [F-2] [F-3] [F-4]
NOTE: If there is a lot of signal noise, turn the
preamp OFF and the attenuator ON (p. 72) to
reduce the input level and improve the readability
of the scope.
5
5
70