D Setting Output Power; Basic Operation; D Setting Microphone Gain - Icom IC-7000 Instruction Manual

D Setting output power

q Push [AF( )] momentarily to enter the Set
set
mode menu.
w Push [F-1 QS] to enter the quick Set mode.
e Push [F-1 Y] or [F-2 Z] to select "RF Power."
r Rotate [DIAL] to set the desired output setting.
• Output power is displayed in 1% steps (0% to 100%).
t Push [Z( )] to exit quick Set mode.
menu/grp
• Available power
SSB/CW
BAND
RTTY/FM
HF 2–100 W
50 MHz 2–100 W
144 MHz 2–50 W
430 MHz 2–35 W
*Carrier power
If a linear amplifier is connected such as the IC-PW1/EURO,
set the output power using the ALC meter (see below) to
the ALC zone (ALC meter reading should be within this
zone), otherwise the linear amplifier will not work properly.

D Setting microphone gain

Microphone gain must be adjusted properly so that
your signal is not distorted when transmitted.
q Select SSB or another phone mode (AM or FM
mode).
w Select S-1.
• Hold down [MENU/GRP] for 1 second once or twice
to select the menu group S.
• Push [MENU/GRP] momentarily one or more times
to select the menu S-1.
e Push [F-3 MET] one or more times to select the
ALC meter.
• "ALC" appears.
r Push [AF( )] momentarily to enter the Set
set
mode menu.
t Push [F-1 QS] to enter the quick Set mode.
y Push [F-1 Y] or [F-2 Z] to select "MIC Gain."
u Push [PTT] (microphone) to transmit.
• Speak into the microphone at your normal voice level.
i While speaking into the microphone, rotate
[DIAL] so that the ALC meter reading does not go
outside the ALC zone.
• Microphone gain is adjusted in 1% steps (0% to 100%).
o Release [PTT] (microphone) to return to receive.
!0 Push [Z( )] to exit the quick Set mode.
menu/grp
• Push [Z( / )] again to return the normal
menu grp
operating mode.
[AF]
[MENU/GRP]
AM*
1–40 W
1–40 W
2–20 W
2–14 W
[MENU/GRP]
ALC

BASIC OPERATION

[F-1] [F-2]
[AF]
[F-1] [F-2] [F-3]
ALC zone
3
[DIAL]
3
[DIAL]
38