Repeater Operation; D One-Touch Repeater Function - Icom IC-7000 Instruction Manual

4
RECEIVE AND TRANSMIT

■ Repeater operation

A repeater amplifies received signals and retransmits
them at a different frequency. When using a repeater,
the transmit frequency is shifted from the receive
frequency by an offset frequency. A repeater can be
accessed using split frequency operation with the shift
frequency set to the repeater's offset frequency.
For accessing a repeater which requires a repeater
tone, set the repeater tone frequency in the FM
tone Set mode as described on the next page.
[MENU/GRP] [F-2] [F-3]

D One-touch repeater function

This function allows you to set repeater operation by
pushing one key.
➥ To set the transceiver for repeater operation using
the one-touch repeater function, follow the steps
q to t as above, then hold down [F-2 DUP] for 1
ANT
15k
BW SFT
1
second.
VFO F M
wo.yip.pp
• Hold down [F-2 DUP] for 1 second again to exit the
METER
Po
14.100.00
1
repeater operating condition
S P L I T
P.AMP
VFO
1 T X FM
Set the offset shift direction and frequency in
wo.tip.pp
ATT
OFF
advance (p. 130) as well as the tone frequency
1 14.100.00
(see p. 64).
Shifted frequency appears.
63
[DIAL]
"TONE" appears.
"DUP–" or "DUP+"
appears.
Shifted frequency
and mode appear.
qw:pp
0
12:00
FIL2 TONE
USB
.
FIL2 TONE
USB
Tone encoder is auto-
matically turned ON.
• To set the transceiver for repeater operation, follow
the steps q to e to select VFO mode, desired
band, FM mode.
q Push [F-4 V/M] to select VFO mode.
• Hold down [MENU/GRP] for 1 second once or twice to
select the menu group M.
• Push [MENU/GRP] momentarily one or more times to
select the menu M-2.
w Push [ )]/[
Y( Z(
band band
band or push a band key on the HM-151.
e Push [MODE] momentarily or hold down for 1
second to select FM mode.
• After FM, WFM or AM mode is selected, hold down
[MODE] for 1 second to select from FM, WFM and AM
modes.
r Rotate [DIAL] to set the receive frequency
(repeater output frequency).
t Select M-3.
y Push [F-2 DUP] once or twice to set the offset
direction.
• " " or " " appears.
• The default repeater offsets are the standard values of
0.1000 MHz for HF, 0.500 MHz for 50MHz, 0.600 MHz
for 144 MHz, and 5.000 MHz for 430 MHz. The offset
can be adjusted in Set mode. (pp. 129, 130)
• The transmit frequency can be monitored while holding
down [F-4 XFC] in the M-1 display
u Push [F-3 TON] to turn the repeater tone ON.
• " " appears.
• The tone frequency can be set in the FM tone Set
mode as described on the next page.
i Communicate in the usual manner.
• Hold down [PTT] to transmit; release [PTT] to receive.
[F-2]
)] to select the desired
.