Ricoh EMP 156 User Manual page 215

Label
Parameter defines what is reported to the host if the selected
font does not correspond to a valid combination of code page
and character set.
Normal: Setting is identical to Relaxed.
Font
Substitution
Strict: Printer reports an exception if the combination is invalid
Relaxed: Setting attempts to report only a few exceptions. If the
selected font is not found, the closest match will be used which
may not contain all the required characters.
When set to Full Capture, the eligible bitmap and outline fonts
Font
transferred from the host are saved on the hard disk. The
Capture
parameter applies to LF1 formats, when code page information
Setting
is also included and to LF3 formats (font character sets).
Default Parameter selects the default code page to be used when a
Code Page code page is not specified within the data stream.
Selects the default font to be used when a font is not specified
Default Font
within the data stream.
Gray Scale Defines gray scale brightness level when printing a color image
Brightness in black and white. One is the brightest, ten is the darkest.
Parameter defines how the printer responds to a Jog command
in the IPDS data stream.
Enabled: Jog commands shall be acted on resulting in the next
Job Offset
printed page being offset from the previous in the stacker.
Disabled: Jog command shall be ignored. Disabling the Job
Offset feature allows the printer to maintain full throughput when
printing short IPDS jobs to the Container Stacker.
Overlay The maximum number of overlays, which may be cached per
Caching job
IPDS Settings- Continued
Action
Allowable
Default
Entries
Normal,
Normal Strict,
Relaxed
No Capture,
No Capture
Full Capture
see Code
500 Page
(Intrn'l #5) Indentifiers
Table
416 (Courier, see Font ID
Roman, Identifiers
Medium) Table
6 1...10
Enabled,
Enabled
Disabled
3 0-12
Web Utilities 6-43