General Printing Problems - Ricoh EMP 156 User Manual

General Printing Problems

If this happens
Paper Jam in Tray:
E1A0, E1A1, E1A2, E1A3, E1A4,
E1A5, E1A6, E1A7, E1A8, E1A9,
E1AA, E1AB, E1AF, E1B0, E1B1,
E1B2, E1B3, E1B4
Double Feed Jam:
E150, E151, E152, E153, E154,
E155, E156, E157, E15A, E15B,
E15C, E15D
Drum Wrap: E17A, E17B
Paper Jam other than
described above, or Paper
Skew
Paper Height Error:
E0BB, E0BD, E0BF, E0C1, E0C3,
E0C5
5-4 Troubleshooting
Table 5-1. General Printing Problems
• Clean the Tray (refer to
• Set the paper and the Paper Guide in the Tray to correct position.
• Turn the paper set in the Tray upside down.
• If the paper has any deformation such as curl, wave, folds, or burrs
remove it from the tray.
• Replace the paper set in the Tray to new one if the paper contains
moisture (refer to "Moisture" on page
• Confirm the Paper Weight setting is correct (refer to
Weight Value" on page
• Try to change the Table Adjust setting (refer to
Adjust" on page 3-23).
• Clean the Discharger/Detach Corotron (refer to
Discharger and the Detach Corotron" on page
• Turn the paper set in the Tray upside down.
• Remove the deformed paper from the Tray if the paper in the Tray has
any deformation such as curl, waving, folding or burrs.
• Replace the paper set in the Tray to new one if the paper contains
moisture (refer to "Moisture" on page
• Confirm the Paper Weight setting is correct (refer to
Weight Value" on page
• Try to change the Paper Moisture setting to the Tray (refer to
the Paper Moisture" on page
• Clean the Tray (refer to
• Set the paper and the Paper Guide in the Tray to the correct position.
• Turn the paper set in the Tray upside down.
• Clean the Discharger/Detach Corotron (refer to
Discharger and the Detach Corotron" on page
• Turn the paper set in the Tray upside down.
• If the paper has any deformation such as curl, wave, folds, or burrs
remove it from the tray.
• Replace the paper set in the Tray to new one if the paper contains
moisture (refer to "Moisture" on page
• Confirm the Paper Weight setting is correct (refer to
Weight Value" on page
• Try to change the stacking level if the stacker jam is caused by the
deformation of stacked paper..
• Clean the Tray (refer to
• Set the paper and the Paper Guide in the Tray to correct position.
• If the paper has any deformation such as curl, wave, folds, or burrs
remove it from the tray.
• Replace the paper set in the Tray to new one if the paper contains
moisture (refer to "Moisture" on page
Try this
"Cleaning Trays" on page
B-6).
3-19).
"Setting the Table
4-57).
B-6).
3-19).
3-25).
"Cleaning Trays" on page
4-57).
B-6).
3-19).
"Cleaning Trays" on page
B-6).
4-54).
"Setting the Paper
"Cleaning the
"Setting the Paper
"Setting
4-54).
"Cleaning the
"Setting the Paper
4-54).